(Your shopping cart is empty)
Search 

Riverwood Shades 'N Shutters is a BBB Accredited Business. Click for the BBB Business Review of this Window Shades in San Antonio TX









Credit Card Processing
Home > Vinyl Plantation    Shutters

> -Shutters For Doors > ByPass Shutters
Choose a sub category:
ByPass Panel Arrangements
ByPass Shutter Doors

Measure for Doors

Measuring For ByPass Frame
  • Inside mounts must have a jamb depth of at least 4", or 5" for flush mount. (Don't forget handle projection, if any).
  • Outside mounts will project 5" plus valance at top.
  • Inside mounts may be ordered without side frames with enough jamb depth.
  1. Measure inside width in 3 places -  top, middle, bottom.
  2. Measure height in 3 places - left, middle, right.
  3. For outside mount: Use larger measurements and add 4-1/4" to width and 2-3/4" to height.  If mounting on top of existing trim, use largest measurements across from outside edge to outside edge of trim and floor to top of trim.  If mounting to wall next to existing trim, add to the trim measurements same as above.
  4. For inside mounts: Use smallest actual opening measurements.  Do not subtract from tight measurements. Factory will take proper deductions.
  5. Locate divider rails by measuring from floor or sill (if window) up to the mid point of the desired location.   
Definition: Mounting shutters recessed within the door opening is known as an "Inside Mount". When mounted outside the door opening on the trim (if any) or directly on the wall, this is an "Outside Mount".
Below are cross section views of typical inside and outside mount assemblies. Actual installation details may vary slightly from illustrations.

NOTE: The floor guide illustrated below is a small guide placed where the sliding sections overlap, to keep them aligned. It is not a continuous floor track.
When sliding panels or when stacked, louvers must be closed due to the limited space between panels.

For illustrations of ByPass panel arrangements, click HERE.
Inside mount- ByPass Frame Outside mount- Bypass Frame

Cross Section of ByPass Assembly, Inside Mount

Cross Section of ByPass Assembly, Outside Mount

(Some minor details illustrated above may vary from actual shutters)


ByPass Panel Arrangements

Get a Quote

Contact Us

Back to Doors